The 150 watt bulb produces 2½ times more heat so unless there is enough air flow round it to take the heat away the temperature will rise and there is a fire hazard. That's why light fittings and lamp shades are often marked with the power limit.
Halogen bulbs generate a lot of heat and for that reason the power (watts) is limited, to prevent a fire hazard. Each light fitting should be marked with a power limit which should be observed. Without additional information a 300 w bulb should not be put in a fiiting that previously had a 230 w bulb.
Yes, you CAN. The real question is whether or not you should. There is always a fire hazard, especially if the lamp is near drapes, or has a large shade or whatnot on it. If it was me I'd only use a 60 watt bulb in a 60 watt lamp.
A wattage recommendation is applied to fixture after extensive testing. It is the bulbs approximation to the fixture that is the main concern. There is a certain amount of airflow around the bulb that is taken into consideration. A larger bulb is considerably hotter and this extra heat is what could damage the fixture. You should always go by the manufacturers recommendation.
You should not use a higher wattage bulb in a lamp that says 40 watts. The higher wattage could cause the lamp to catch fire due to the excess heat and could cause you serious electrical problems.
No...
a lamp uses electricity and a light bulb, a torch is fire
Halogen bulbs generate a lot of heat and for that reason the power (watts) is limited, to prevent a fire hazard. Each light fitting should be marked with a power limit which should be observed. Without additional information a 300 w bulb should not be put in a fiiting that previously had a 230 w bulb.
no,not if you have the towel on top of the heat lamp, but if you have the towel underneath it then it is possible
Yes, you CAN. The real question is whether or not you should. There is always a fire hazard, especially if the lamp is near drapes, or has a large shade or whatnot on it. If it was me I'd only use a 60 watt bulb in a 60 watt lamp.
No. An hid bulb has a transformer (ballast) that produces a certain voltage needed to fire the gas in that lamp.
If your hazard lights don't work but your turn signals do work it could be that your Hazard Lamp Flasher needs to be replaced. Your car has both a "hazard lamp flasher" and a "turn signal lamp flasher". Your "turn signal lamp flasher" is working but your "Hazard Lamp Flasher" may not be working. Buy a new "hazard lamp flasher" and install it. The hazard lamp flasher is located behind the instrument panel to the left of the steering column.
A wattage recommendation is applied to fixture after extensive testing. It is the bulbs approximation to the fixture that is the main concern. There is a certain amount of airflow around the bulb that is taken into consideration. A larger bulb is considerably hotter and this extra heat is what could damage the fixture. You should always go by the manufacturers recommendation.
Lamp have required high rating to glow & have a specific luminus area.exa-table lamp,florucent lamp,sodium vapur lamp,BUT but bulb have no required rating exa- halogin bulb
You should not use a higher wattage bulb in a lamp that says 40 watts. The higher wattage could cause the lamp to catch fire due to the excess heat and could cause you serious electrical problems.
No...
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
A subsystem for a lamp would be the bulb because the bulb lets the eye see.