How can I install a walk in tub shower myself?

Answer 1

I assume you mean in a finished house.This is gonna get messy.Most bathrooms have a 24 in.door, which means a 32 in.unit will not go thru.you will have to gut the door.Then there's the length to contend with.Tubs are set in place before sheetrock is set,so you'll have to gut the rock as well.The other option is to go thru the outside wall.the third option is to get a unit that comes with the walls separate from the tub,with less demolition.When the tub is in, place a small torpedo level on the floor ,side to side. When level, nail or screw in place.

Answer 2

They usually come in 5 parts and are glued to the wall with 3-4 tubes of adhesive. I prefer to use PL200, but others are also suitable. First glue the back wall in wavy lines, then stick the back panel on, then same with each end. Next, and more carefully, glue on the overlapping transition pieces at each end corner. Now press all panels from centre outwards to expel any air trapped by the glue. Finally leave everything to harden for 30 minor so, then run a bead of waterproof silicon caulk all round the top edge. - I forgot to mention, on the faucet end panel, holes must be drawn and cut out where pipes go, and faucet must be removed and replaced later.

Answer 3

Installing a walk in tub is much like a regular tube. You must have knowledge of the piping and and the proper tools for removing the old tub. Step by step instructions can be found online.

You should hire a contractor to install a walk in tub shower

Answer 4

Here is a video detailing a tub installation: http://www.YouTube.com/watch?v=BuITI1yfhBg Here is a step-wise guide to the installation: http://www.essortment.com/install-walk-in-bathtub-shower-11748.html I would also recommend you seek the advice of a professional if you do not have experience in this type of project.