If your failsafe engine light comes on you need to clean your throttle body and have the electronics rebuilt. To remove the throttle body first disconnect the battery. Then disconnect the air cleaner held on by one clamp. Remove the two electrical harnesses from the throttle body. Make sure to move the red tabs to be able to depress the other tabs. Then remove the two engine coolant hoses. The throttle body is held on by four bolts connected to the intake manifold. Remove these bolts and the throttle body should come off. Clean the throttle body thoroughly with throttle boby cleaner and a rag. If you have heavy carbon build up, then either the "special coating "is no longer there, or it's still on and not worth the dam. In either case you can't hurt anything by cleaning it. Go on E Bay in the throttle body catagory and look up BBA remanufacturing in MA. Ther will charge you $320.00 to rebuild the electronics. That includes shipping both ways. When you get it back install it using a new gasket. Connect the battery and you have to reprogram the computer. They will send you instructions on how to do it. It's very easy. That should take care of your failsafe engine light. P.S. I sprayed some silicone in the throttle body, and wiped it out. Good luck.
2000 s-type jaguar
How do you set the clock on a 2000 s-type jaguar?
A liter of engine displacement.
Cfg
The 2000 Jaguar S-Type OBD 2 port is on lower edge of dash; right of steering column
in the trunk
No
You can not add fluid to the Jaguar 2000 S-Type as it has a sealed transmission box. It must be taken into a mechanic to have the fluid changed.
2000 4.0 jaguar s type cylinder firing diagram:FRONT OF CAR5 16 27 38 4
Inlet or Exhaust?
i use the one with an engine garrunty
Go into your Jaguar dealer and ask them, just need the reg number