0
High precision op amp offers wider output voltage swing and noise.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you enter the radio code into a rover 214 factory radio?
You need two U shaped pins that go into the 2 holes on either side of the radio, you push them in and the radio should just pop out. The pins can be made out of welding rod....
Do car keys use radio waves?
yes,they do use radio waves
How do you set radio channels on the radio?
you use the dial
Putting a aftermarket radio in a 2000 sable?
Go to Circuit City and get a harness kit! You will need the harness kit that is available at Best Buy and other locations. However, my 2001 VW Cabrio did not have a switched +12V source (source that turns on or off with the ignition key). Without a switched +12V source the radio will remain on when the key is removed from the ignition if you have not manually turned the radio off and your battery will be drained. A switched +12V source is available from the rear defroster switch (black and yellow wire). Connect a wire from this switched +12V source to the red wire of the harness kit. You must also cut or remove the red wire from the socket of the wire harness kit because it will be connected to a non-switched +12V source of your car.
A device used to detect radio waves from space?
they use radio waves to pick up some what satellite images or existance of things in space
Why you use current source in data transmission?
A: The main advantage for a current source transmission is low source impedance. extraneous voltage influence is reduced by that characteristic.
A dc voltage source of 10V is in parallel with a current source of 5A and a resistance of 1 ohm what will be the current across the resistance?
use kvl or kcl
Why do you always use voltage source in lab not current source?
Current is created by voltage (potential difference), not the other way round. It's the voltage - or 'push' - that is making your current move.
How do you use a current divider rule?
I?=I source(R equivalent / R?)
What kind of energy source does a transformer use?
Electrical (alternating current)
Does a stick welder run on ac or DC?
For output, either one. Most machines produce Direct Current DC. It is much easier to use and most electrodes can be used with DC. Almost all use Alternating Current AC for a power source - input. Hope this helps.
What source of heat does a halogen light use?
an electric current passed through it
Do radios use magnets?
Yes, they do. You need small electromagnets in the speakers so that you can hear the radio station. The incoming radio signal is converted to an electric current by the aerial, boosted by circuit boards in the radio, then transmitted by the speakers by using the current to vibrate the electromagnets.
What do you use to make a amp or light fitting light up?
A lamp or light fitting will light up if connected to either Alternating Current (AC), or Direct Current (DC). AC is from the mains, and DC is from a battery. So it depends on the construction and components used to construct the lamp as to which electrical source you use.
Why you use current source?
Current source can be helpful in application where you want to measure very low resistence like a wire for example. The basic idea behind this is to fix the amount of current and then measure the voltage across the wire.
How do you look at the back of your car radio?
You can either take it out, or you can use your x-ray vision.
Can you use more than one source of voltage in a circuit?
Yes, you can use more than one source of voltage in a circuit. You can also use more than one source of current in a circuit. In fact, complex circuit analysis can utilize Norton and Thevanin equivalents to convert part of the circuit from current source to voltage source and vice versa, allowing you to eventually understand the complete circuit.
