answersLogoWhite

0


Best Answer

Yes you can use both. They are also acutally the easiest way to find a short in an automotive circuit.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can a tone generator be used to locate a short circuit?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

How do you use a circuit breaker finder?

My unit requires you to plug in the tone generator to the outlet whose corresponding breaker you are trying to locate and turn on the tone. You then go to panel with receiver and hold button in while running the receiver up and down the panel. You will hear a tone once the breaker is located.


What is the purpose of a tone generator?

A major purpose is to generate test signals for troubleshooting purposes. Sometimes they are also used for sound effects generation for plays, movies, radio dramas, etc.


Where can we purchase a tone generator?

Ex tech generators are the one we purchased . We got the product from amazon and there are other good brands too. The product also had good reviews which enabled to understand the utility and the efficiency of the product .you can even check in big electronic stores.


What device to find out a defective light bulb in a series circuit?

To find a faulty bulb in a series circuit, measure the voltage drop across each bulb. The bulb with the highest voltage, specifically the source voltage, is the one that is open.In the opposite case, when the faulty bulb is shorted, it will have zero volts, while the others have slightly higher than normal voltage.In the case of series connected Christmas Tree lights, it is a bit complicated because it is hard to measure voltage while the bulb is plugged in.You could plug each bulb, one at a time, into a working string, or you could measure the resistance of each bulb, looking for infinity. Note, however, that modern series connected Christmas Tree lights are designed to short out when they fail, so it is a simple matter of seeing which one is not lit. (If too many bulbs, however, are shorted, the string will pull excessive current and either all bulbs will fail or the string fuse will blow.)


How does the warble alarm siren works?

Basically, all that happens is an integrated circuit produces an output signal of 1010101010101010 over and over again. A second one processes it into a tone such as 1=1.8khz 0=2.6khz. This series of tones is then fed into a piezoelectric sounder.

Related questions

Where could one find a free tone generator online?

One can find several places online for free tone generator software. One can visit companies such as: NCH, Ring Bell, Online Tone Generator, Tucows, and Expression Tone Generator.


How do you use a circuit breaker finder?

My unit requires you to plug in the tone generator to the outlet whose corresponding breaker you are trying to locate and turn on the tone. You then go to panel with receiver and hold button in while running the receiver up and down the panel. You will hear a tone once the breaker is located.


What is the procedure in chasing an outlet?

I am assuming you are trying to find all outlets that are connected together in a circuit. The easiest way is to have a tone generator. They make a few different kinds. In one you plug in a tone generator that is built into a standard AC plug and you can put the receiver at the electric panel to locate the breaker that controls that outlet and you would do this for all outlets by "Toning Out" each outlet in question. In another method you connect a tone generator to any outlet and then use the receiver to see which other outlets have the tone present. In this method you should turn off the power to the outlet you are using as the starting point. If you have no tone generator you can turn off breaker for the outlet where you will start and use a volt meter to find all other outlets that are off. You can get a good toner for $20 to $30.


What is the cause of a constant tone or alarm that is similar to constant seat belt alarm after starting and driving a 1994 Jeep Grand Cherokee Ltd?

It is a short in the onboard computer display. I pulled out the tone generator located under the dash to the left of the steering wheel. It is purple. Pulled it out and no more annoying tone.


Where can I find a Tone Generator?

Tone generator can be found in the shops like best buy and Walmart. It can be also be founding stores like amazon and other product stores like buy and deals buy.


Anti side tone circuit in telephone is used to Amplify side tone suppress side tone Eliminate side tone attenuate side tone?

attenuate side tone


What is a small electronic device that issues a signal on a wire pair?

Tone generator


What tone generator is used in a Korg TRITON keyboard?

All Korg TRITON keyboards use Korg's HI Synthesis tone generator. Each keyboard can be upgraded in a number of ways and as a result, they are very popular with musicians.


Where can you find a cheap tone generator?

It depends if you want an online tone generator, there is one at: onlinetonegenerator.com/. There are some generators at Amazon.com that you can buy. The used generators are a lot cheaper, but you also have to pay for shipping and handling. You would not have to worry about the newer tone generators, because they should last longer.


What KVA generator is required to run two AC of 1.5 ton?

How much KVA generator is required to run two AC of 1.5 tone


Where can you get a tone generator for the treatment of tinnitus?

ask your doctor Answer 2. An Audiologist would be the best person to ask. They are educated and trained in evaluating all types of hearing problems and would know what treatment to recommend. If a tone generator is their recommendation they would know where to get it.


What is the tone in a pair of silk stockings by kate Chopin?

the tone of this short story is fanciful