Say the wire attached to a wall plug is not screwed tightly onto the terminal. If you plug something like a heater into that outlet, the current flow across that loose terminal will get it warm and as time goes on even hot, even hot enough to start the wall on fire.
A short in the wring can cause heat and a spark which can start a fire.
If by 'cable wire' you mean Coax cable for the TV, or Internet, then the answer is no. The power/voltages in the cable are way to low to produce a spark which is usually what triggers flame. If by 'cable wire' you mean a cable carrying an electrical service such as 120V or 240V, then, if the cable is damaged by an accidental or deliberate cut which causes a short circuit from a hot phase wire or wires to other wires in the cable - such as to other hot phase wires in a 3-phase circuit, a neutral or a ground wire - then the resulting heavy current could result in the cable becoming very hot and could cause it to catch on fire unless there was some overcurrent protection device to prevent that from happening. That is why fuses and/or circuit breakers should always be included in any electrical service wiring to cut off the supply of current before a fire can be caused by such damage.
Poor cable connections, accumulated or stray magnetic fields, high amount of electrical noise, or vertical scan frequency (refresh rate) below 70 Hz can cause monitor flicker. Page 423 in the A+ guide to managing and maintaining your PC, Sixth Edition
Cable melts because of heat. That heat can come from two sources. Either the cable is directly shorted with another side of the power line, causing extensive heat and load on the cable to the point of failure. The other way is through overload of wattage on the guage size of the wire. The lower the guage number, the greater the capacity to carry higher wattage electrical loads. If there is a 'bottleneck' in the flow of high wattage loads through too-small wires, they will heat up, eventually melting all insulation.
The water can cause circuits to short or ground out, with hazards of electrical shocks or fires.
You can install the 110v line on one stud and the coax jack on any other, just don't put them on the same stud. This will cause major crosstalk in the coax line.
Yes, if the cable is cracked and swollen it has a high resistance thus causing a loss of current. Replace any cracked or swollen cable.
its electronic cause of the distributorless ignition.
Its either a faulty cable or a faulty electrical connection.
cause it did
I wouldn't suggest you do. If for some reason your plumbing leaked or exploded this could cause an electrical fire because of the electrial lines which obviously could cause some serious damage. Answer Another reason to avoid this option would be because if you run electrical cable next to copper piping it can cause electrolosis and this can weaken pipes and cause them to burst resulting in the above answer.
The Revolution In Russia
The responses of the US and the UUR did cause a major inclination in the outbreak of the WWII as allies combined.
It was the main cause
Cadmium poisoning.
Many factors contribute to the outbreak of wars.
No as he is now dead.
It was the main cause