Typically, spark wires are encased in a flexible plastic tube which is secured in usually 2 places with special clips. The tubing material gets brittle over time and cracks /breaks easily so patience and being careful are the key. After you remove the tube from its mounting points, you will notice that the tube has a split over its entire length. Carefully spread the split open at on end then pull (one wire at a time through the split. then reverse the process with the new wires..... unfortunately this is even more difficult and requires even more patience... good luck.....Ronco
the plastic becomes weak
Something that is attached to the structure that can be removed.
There are 5 nuts that need to be removed. 2 on the drivers side under the plastic cover and 2 on the passenger side near the back. The 5th nut is in the center on the floor and is attached to a v-cable that is also attached to the back of the seat. After the bolts are removed the seat needs to be lifted straight up to get the tabs at the top of the seat out of the holders.
Scratches can rarely be removed fro plastic. The only way to remove scratches from plastic is to melt the abrasions.
Remove the plastic "filler panel" between the radiator mount (top) and the front grill on the driver side. They are attached to the radiator mount (top)and are not visible unless the "panel" has been removed.
Crocodile
Yes, if the plastic is left in it for long periods of time it will dry rot the plastic when it is removed from the rubbing alcohol.
mandables are removed last because attached to them are the maxillae and aixilliped, so those would be removed before, leaving the mandibles last.
You can find it under the dash, above the brake peddle. It is located behind a plastic cover that is held with one screw. Original may be lime green in color and is held in place with plastic clip that can be easily removed from metal frame it is attached to. Original may be shorter then replacement.
Yes they are the same just plastic surgery has added silicon which can be easily removed.
Its on the top of the steering column underneath the plastic piece.There are 2 screws underneath the column that need to be removed so that the plastic piece can be removed, and then once removed you can see the flasher. its a square black box.just unplug and replace.
yes it can if your are wearing the right protection