answersLogoWhite

0

Take it out of four wheel drive.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you tell if your Over Drive is on or Off on your 1999 Jeep Grand Cherokee?

If there is an OD off light on the dash, overdrive is turned off.


How do you turn a check engine light off in a Jeep Grand Cherokee?

try unplugging the battery for a while. that may turn it off IF you fixed the problem that turned it on.


Where is the airbag light on 96 Jeep Cherokee Sport?

No light on 95-96 cherokee. Thay are a self-contained unit.


How do you install passenger tail light kit for a 2004 Grand Cherokee Laredo?

How do you install passenger tail light kit for a 2004 grand cherokee?


When a light switch is turned on what is done to the curcuit?

When a light switched is turned on the circuit is usually closed.


'The light my dashboard in my 95 Jeep Cherokee does not work?

so you replace the light


Why my monitor fickles when turned on or it shows a light in the middle of screen when turned off?

why the monitor very light


Does the light bulb use up current when it is turned on?

Yes, the light bulb uses current when it is turned on.


Why on a 2000 jeep Cherokee Laredo the left brake light goes off when the lights are turned on yes you replaced the bulbs?

Check the ground wire between the socket and the vehicle chassis and make sure that the connection is good.


Can a light bulb blow out if it's turned off?

No, a light bulb cannot blow out if it is turned off. Blown light bulbs occur when they are turned on due to the filament burning out or electrical issues.


When a light switch is turned on what travels through the wire?

Current flows through a wire when a light switch is turned on.


How do you rewire brake lights on a Jeep Cherokee the brake light goes out when the headlights are turned on?

You need to check your light sockets and the connections in your lens assembly. Over time, the prongs in the lens assembly seem to wear down. You need to prop these up with a small screwdriver,lights should work fine. If not, check your light switch.