answersLogoWhite

0


Best Answer

If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this. If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can you by pass an inertia switch on 1993 Ford Probe?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the inertia switch on 1993 Ford Probe?

hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.


Where is locate inertia switch Ford Probe 1993?

On the passenger side, under a cover in front of the door, on the side of footwell


Where is the inertia switch on a 94 Ford Probe?

in the trunk. under the carpet, in the leftside quarterpanel


Does a 1993 Chevy S10 pickup truck have an inertia switch?

No it does not. That is a Ford thing.


Where is the inertia switch in a 1993 Ford Mustang LX?

On a 1993 Ford Mustang : Open the trunk lid or the hatch Between the rear tail lights you will see an oval shaped rubber plug The inertia switch is behind the rubber plug


Where is the inertia switch for a 1993 E150 ford van?

Passenger side lower kick panel


Dia gram of starter location 1993 ford probe?

diagram of starter in a 1993 ford probe


Where is the fuel pump reset switch located on a '93' Ford Probe?

If you are talking about the inertia switch, it is in the hatch on the driver's side under the floor mat behind the wheel well.


Where is the inertia switch located at on a 1993 Ford Ranger?

I'm not a mechanic / technician but I BELIEVE the fuel pump inertia switch on a 1993 Ford Ranger is in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump


Where is inertia switch on Cadillac?

Ford vehicles have this switch, no GM vehicle use an inertia switch.


Where is the fuel pump shut off switch on 1993 Chevrolet truck?

If you mean "inertia switch", it doesn't have one. That's a Ford thing.


How do you reset the relay fuel pump on a 1993 ford mustang?

you push the red reset button on the inertia switch