Check the network card and the properties are listed there.
The TCP/IP information is supplied to any DHCP client on the network connected to the FastEthernet 0/0 interface of R1
issue the no shutdown command on interface FastEthernet 0/1
It can also be called a network interface controller, network interface card, network adapter, and LAN adapter.
Just properties of the network card. The speed of connection is there. Knowing the speed and capabilities of the network card you are looking at, you can find out which interface is used at another end. PS: The speed you will see is the highest both devices can support in the same time.
NIC Network Card Interface is a hardware component without which a computer cannot be connected over a network. It is card or chip which contains MAC address which actually helps to identify the device on the network.
Router is a Layer 3 (Network Layer)device that checks packet's IP Address at input interface & routes them to interface connected to destination network if available.
the category type of the cable is usually printed on the cable itself.
computer
Probably your NIC or network interface card is bad on the offending computer, or you have a software issue.
1) Network Information Center 2) Network Interface Controller
netsh interface ipv4 show interfaces
The command is: netsh interface ipv4 show interfaces