0
What else can I help you with?
Why cable IDE have a twist?
The twist is to identify the connector which is assigned for drive A.And the other end connector is for mother board.
Identify the connector that can be used to connect RG6 cables?
The "F" connector is the most common type that is used on RG6 cable. This is the universal connector for home use of RG6 with antennas, CATV, satellite, and consumer electronics.
What kind of connector does a Ethernet cable use?
The UTP cable it uses an RJ-45 connector. For coaxial cable, it will be either an F connector or a BNC connector.
Name of a cable connector that would be used if the cable was coaxial?
BNC connector
How many pins does a fdd cable connector have?
34 pins in a FDD cable connector.
There are three female connector cable and one male connector cable attached to the?
distribution box
How do you attach the alligator clips of the Kurth KE300 to your coaxial jack in your wall?
One clip will connect to the center conductor of the coax cable, and the other clip connects to the shield, or the ("F") screw connector of the cable. With the probe, this will allow you to identify your cable at the main distribution point. If it is still connected to the cable system, you may have to disconnect the cables to correctly identify YOUR cable.
What joins a cable to a port?
A connector you fool
What is an RJ45 Connector used for?
An RJ-45 connector is the the connector at the end of a Cat-# cable (also known as a lan cable/network cable).
What is cable connector?
It is a cable that can connect to other cables
What is a cable gland?
A cable gland is a connector which holds the end of a cable in place.
How many pins does EIDE connector?
EIDE cable uses a 40-pin connector at the end of the cable to interface with the drive.
