The simplest way would be to use an ohm meter. To measure it correctly it should be disconnected.
A component of a given size that offers low resistance is called a good conductor.A conductor having some appreciable resistance is called a resistor.A component of identical size that offers a higherresistance is called a poor conductor.An insulator of the same size offers even higherresistance.
RESISTANCE
If there's no influence from air resistance, then the path of a "projectile" is a parabola. That's what you get when one component of velocity is constant and its other (orthogonal) component is accelerated.
They are the same, if the effect of air resistance is ignored.
Because there's no horizontal force acting on it that would change its horizontal component of velocity. (In practice, that's not completely true, since the frictional 'force' of air resistance acts in any direction. But outside of air resistance, there's nothing else acting horizontally on the projectile.)
Residence of one component varies overtime and from component to component.
Resistance.
A voltmeter has the large resistance.The voltage across any component can be measured if & only if the terminals of that component will be open and this will we can acheiv if we connect the high resistance voltmeter across the open terminals of that component to measure the voltage.
Yes
Zero.
It measures resistance in a component or circuit to determine if there is a break in that circuit or component. If there's no resistance, it means there's a break, as no electrical current is passing through.
A measurement of opposition to electric current flow in a component or circuit.
IF there is a Resistor
Resistance is the property of a component which restricts the flow of electric current.
Power dissipated by the entire series circuit = (voltage between its ends)2 / (sum of resistances of each component in the circuit). Power dissipated by one individual component in the series circuit = (current through the series circuit)2 x (resistance of the individual component).
yes you can! you can use a multimeter and a resistor.
The ohm symbol is used to represent resistance of a component or in a circuit