If neither of the brake lights come on when the brake pedal is depressed, you should check the break light switch which is usually located behind the break pedal assembly. Look for a losse or disconnected wiire to the switch. If one does light up them you need to check the led bulb to see if it is good or needs to be replaced
Tail lights and break lights are different things pretty much all the time. You see, tail lights run all the time the car is on and break lights only turn on when the break is pressed. If you would like to find out which lights are the breaklights, have a friend watch the back of the car, turn it on, push the breaks a few times and see which lights flash. The lights that flash are your break lights!
Begin I removing the tail light connector. Take hold of the tail light, push in and turn at the same time. The tail light will come on. Reverse the process to install your new tail light.
Could be a bad bulb. The same bulb has two filaments, one for the tail lights and one for the brake lights.
Tail lights inop all the others are ok Break lights in the same socket are ok / No power to the tail light side of the socket
Hello, all you have to do is turn the back of the light post and pill the lights out for both the fog lamps and the break lights. For the break lights, its less work to change.
Should be the same fuse for parking light/tail lights Should be the same fuse for parking light/tail lights Should be the same fuse for parking light/tail lights Should be the same fuse for parking light/tail lights
You can change the rear lights in your 2009 Ford Fiesta by removing the interior panels behind the tail lights. Push the light clip and turn it. the light will pull out to be replaced.
Turn your headlights on. Walk to the back of the vehicle and look for any lights that are out. If the lights are all on. Have someone press the break pedal and look at the light again. If any lights are out replace them.
Generally, dash lights and tail lights are on the same fuse so that if the tail fuse blows you'll know. When the tail light was "smashed", it shorted out the circuit and blew the fuse. You need to fix the tail light before you can get the dash lights to work.
If your referring to tail lights just turn off your headlights and they will turn off. If your referring to break lights take your foot of the break pedal.
inside your trunk behind the rear lights there are two plastic circles that pop out to access the tail lights, once these are out you should be able the push the light out .
replace the break light bulbs?