answersLogoWhite

0

What else can I help you with?

Related Questions

Where is the crank sensor located on a 2003 Grand am?

its been my experience , if its a 3.4lt, it has two sensors for the crank, one in the block. and one in front cover near crank.


Where is the crank sensor on 2003 grand am?

where is crank senser located on 2003 pontiac


Why wont 94 jeep grand Cherokee limited 5.2 wont start and no spark after changing transmission?

somebody broke or didn't connect the crank sensor


Where is the crank sensor on 1991 grand prix?

The crank sensor on the 3.1 is on the firewall side of the engine, about halfway up the block, Difficult to get to. They are VERY BRITTLE, so take your time prying it out. You have to get at it from under the car and it is retained by one 10mm bolt. Good luck!


Where is the crank sensor located on a 1993 Grand Prix with a 31 Liter engine?

the crank sensor is somtimes located on the top of the oil pan. i know it is atlest on the 91. side of the block just below the exhaust manifold it takes a 10 mm socket


Where is the crank sensor for a 1992 Pontiac Grand Am?

The crankshaft sensor is on the side of the engine behind the alternator. It is mounted close to the oil filter,


2001 Mercury Grand Marquis 4.6L crank sensor location?

next to the crank pulley


Where is the crank sensor located on a 4 cylinder 2002 Pontiac Grand Am?

For the 2.2L engine, remove the starter. The sensor is screwed into the engine block behind the starter with a 10mm bolt. The wiring plugs into the front of the sensor facing the radiator.


Where is the crank sensor on a 2000 Pontiac grand am 3.4 L?

it is on the engine


Have a 1999 Jeep Grand Cherokee just had the crank sensor replaced they claimed that the cransensor broke and they needed to remove the oil pan to remove the censor is this true?

depends if it broke at the thread or not but most defo not coz it is located on out side not in


Where is the crank position sensor in 2000 jeep grand Cherokee with v-8?

It is above the starter. You must remove the started to get at the CPS. There is one bolt that holds the CPS in the block.


Would a crank shaft sensor and cam sensor cause your 2002 dodge grand caravan to not turn over and or start at all?

A bad cam or crank sensor can cause a no start, but the engine will still crank or turn over.