0
What else can I help you with?
Why does my Chrysler Sebring when put in drive or reverse behaves like its in neutral what may be the problem?
Could be low on transmission fluid. If so you have a heck-of-an oil leak.
What is a transmission range sensor on a 1996 chrysler sebring?
The transmission range sensor tells the ecm (electronic control module - the cars computer) which shift position the shifter is in (ie= PARK, REVERSE, NEUTRAL, DRIVE, 3, 2, 1).
How do you replace the starter on a 2001 Chrysler Sebring convertible?
Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
How do you replace the alternator in a 2000 Chrysler Sebring convertible?
When replacing the alternator on a 2000 Chrysler Sebring convertible begin by removing the belt. Next, remove the wiring. Lastly, remove the retaining bolts. Reverse the process to install the new alternator.
How do you change the battery on a 2010 Chrysler limited sebring?
The battery, on a 2010 Chrysler Limited Sebring, can be changed by first removing the battery cover. Remove the battery cables and the retaining bolt. The battery will left out. Reverse the process to install the new battery.
How do you fix the reverse gear on a 1986 chrysler's Fifth avenue?
get a new transmission or rebuild yours
How do you replace the battery in a 2003 Chrysler Sebring?
Remove driver side front tire. Remove inner fender liner. Remove battery. Reverse steps.
Why would you have only low and reverse on your 1994 Chrysler LHS?
Try replacing both transmission speed sensors (around $20 each located on transmission)
Why will a 1989 Chrysler New Yorker not shift into reverse?
Shift cable adjustment, low fluid, internal transmission failure.
What does dtc code p1776 for a 1999 Chrysler sebring mean?
Code p1776 is solenoid switch valve latched in low/reverse position. Valve is located in valve body not solenoid body.
Where is the reverse light switch on a 1990 chrysler lebaron?
On a 1990 Chrysler LeBaron, the reverse light switch is typically located on the transmission. It is usually mounted on the side of the transmission case and is activated when the gear selector is moved into the reverse position. To access it, you may need to lift the vehicle and remove the necessary undercarriage components for better visibility. Always consult the vehicle's service manual for specific details and diagrams.
What does it mean if your 1999 Chrysler sebring jxi will go in reverse fine but wont get out of 1st gear going forward?
You need to have the system checked for codes. Any electrical problem with the trans can cause a no shift.
