you check the insulation and it is degraded,hole in it or it does not have a very high ohms of resistance,which means the insulation is bad.
nothing seems to be broken. the cable is not connected to the drive bracket
You need to find out what output connections are on your soundboard and what input connections are on your amplifier. If you don't know this, a 1/4 inch cable usually will work at both ends.
i dont know what you mean but all you need would is a av cable compatibility t.v .
Yes, we have replacement power cords available for AC units that need to be replaced.
Need to know what the voltage applied to the cable is.
either your neutral safety switsh is bad or your connections are bad or the slow burn fuse on the positive cable has blown(that is the big round thing on the positive cable) the cable will need to be replaced if that is the case. this can be determined by using a test probe behind the fuse and seeing if you have power. if not then that is the problem.
Since you replaced the sensor, and the speedometer still isn't working it is possible that you will need to replace the speedometer cable. Check the cable first to be sure that it is still properly connected, and if so replace the cable to see if that solves the problem.
This unit requires a PWM power supply.
The only cable needed for a wireless printer is the power cord.
Difference_between_copper_and_bronze
Sounds like the clutch is slipping and needs to be replaced - if cable was stretched clutch would not disengage and vehicle would creep in 1st gear and shifting would be difficult
If it's an analog speedometer, first check the condition of the speedometer cable. It may need to be replaced.