answersLogoWhite

0

How can you locate the starter in a '89 Mercury Topaz?

Updated: 8/16/2019
User Avatar

Wiki User

16y ago

Best Answer

Just look under the front of the car, just behind the rad. And there it is, if it is a 4cyl of course?

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can you locate the starter in a '89 Mercury Topaz?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

You have a 89 mercury topaz and it won't turn over is it possible to tap the starter to get it started just to get it to point A?

if the starter is good , then its possible. do you know how to do it?


Where can you locate the Starter on a 89 Mercury Topaz?

All starters are somewhere near the flywheel or flexplate, as the starter turns the flywheel or flexplate. That is located between the transmission and engine, but not visable. You will find a heavy gauge wire attached to the starter that will directly or indirectly run back to the battery positive terminal.


How many cans of r-12 does an 89 mercury topaz take?

R-12 is not sold anymore.


How do you locate the starter on a 89 Honda Civic LX?

it's right next to the transmission


Where is the fuel filter located on a 1989 Mercury Topaz?

Feul filter for 89 topez is mounted on the passengers inner wheel well


Where is starter on 89 Ford F-150?

Location of starter on 89 ford f150


Where is the starter solenoid located on an 89 VW Cabriolet?

it on the starter


Where is solenoid located on 89 blazer?

The starter solenoid is attached to the starter.


Where is the starter relay on 89 Electra Park Avenue?

Usually on the top of the starter


Where is the oil drain plug on the 89 topaz?

Should be the rear lower section of the oil pan


Change the head gasket on a 4 clynder 89 Mercury Topaz?

Have to remove all the top parts of the engine and the valve cover. Then the head bolts. Have the head sent out to be checked and a valve job. Head bolts must be torqued when replaced.


How do to install a starter on a 89 Chevy Camaro?

The starter on an 89 Chevy Camaro is installed by placing the vehicle on jack stands, attaching the starter wires, and aligning it with the mounting holes. The bolts are place in the starter, torqued down, and the shroud cover attached.