Turn the collar and the flame will get hotter
It's the part of the Bunsen burner which lets in air, adjusting the strength of the flame. basically the hole at the bottom with the twisty bit.
A man named Michael Faraday created and invented the Bunsen Burner, Robert Bunsen improved it by making the flame cleaner, hotter and non luminous. The Bunsen Burner was named after him, but that does not mean he made it.
You need to close the hole and plug it into the gas point then light the match and then turn on the gas, to make the flame hotter open the hole.Note: do NOT light the Bunsen burner next to flammable substance
Flames need air to expand and grow, or become hotter. The oxygen circles the flame and makes the flame alter. The collar allows air to get to the flame.
IN a cupboard but make sure there is a plastic basket and the Bunsen burner must be cooled before stored.
By using the correct ratio of oxygen and fuel mixture. Opening the air hole in the Bunsen burner increase the oxygen which helps the flame burner hotter .
how do you make the flame on busen burner bigger
Because more oxygen is needed for fuel for fire.
Twist the collar at the bottom of the Bunsen burner to allow more oxygen to mix with the methane. This will produce a blue flame that is very hot and may be difficult to see, so be careful.
if you are talking about what flame to use on a Bunsen burner than the yellow flame is to make sure that everyone knows that there is a flame but the blue flame (less visible) is used as the hotter flame and the better one.
You can make the flame hotter by first, lowering the flame from the starting point by slowly closing the gas valve until the flame is at a medium height. Then, you should increase the oxygen intake by slowly opening the oxygen valve until you have a completely non-luminous flame (an all-blue flame), which is hotter than an orange or yellow flame.
It is closed to make a safety flame.
It's the part of the Bunsen burner which lets in air, adjusting the strength of the flame. basically the hole at the bottom with the twisty bit.
I'm only in Yr 7 and i know,anyways the characteristics are what it contains a safety flame is when the flem is on and orangey colour and is not as hot as the blue flame.For example you are using a Bunsen burner (you gotta have used a Bunsen burner at least once at scholl cause i have,any ways the blue flame is always hotter than the orangey flame (the safety flame) because to make a blue flame you need to open the Bunsen burner jacket to let oxygen pass through.Sp the characteristics are that the safety flem is an orangey cour as oppsed o the blue flame,which is also much hotter than the safety flame.
To get a roaring (blue) flame you simply turn the sleeve on the Bunsen burner's chimney to completely open the air hole under it. The new blue flame will be hard to see so close the air hole afterwards to make a visible flame.
you make sure that the nosel is covered otherwise it wont be a safe flame
close the air hole by twisting the collar