there is a manual release in the trunk for it , there is also a relay that controls the release located under the rear seat in one of the fuse blocks located there
The door speakers in an Oldsmobile Aurora measure 6 inches by 9 inches. These speakers are located in the rear deck.
The only Aurora 2 door is a LeMans race car.
Oldsmobile was the maker of the Aurora car. The car was a mid-size luxury sports sedan that was produced between January 1994 and March 2003. It was used mostly by families because it was a four-door car.
Door plunger switch broken or bad.
you need to change the window regulator
fuel filter should be fastened to frame under left rear door. remove and replace.
To replace the blend door in a 1998 Oldsmobile Aurora, first disconnect the battery and remove the dashboard trim to access the HVAC controls. Then, take out the heating and air conditioning unit to reach the blend door assembly. Remove the old blend door and install the new one, ensuring it is properly aligned. Reassemble the HVAC unit, reconnect the battery, and test the system to ensure it operates correctly.
in the trunk on the drivers side near where the fuel fill door is at you`ll see a plastic tag hanging there just pull on it and the lid will open.
For a 1996 there are 2 screws 8mm I believe on the very bottom. There is also a screw behind a cover by the door lever. The entire door will lift up, then out.
Remove the door panel. Towards the front of the door there are two screws holding the mirror on. Inside the door are two connectors that connect the mirror wires to the door. I have a 98 and if it is the same process that's all you need to do.
The mfg. recommended psi's are listed on the door jamb.I run 35 psi for good tire life and good handling.
You have to remove the door panel and attach the new window to the window frame this is very easy but it is time consuming and make sure you have no air leaks before you put the door panel back on