Unfortunately this will be difficult at best. Both are plastics. Spray foam is very tenacious. It bonds really well to most things (including tubs). That said; I have been successful at removing overspray from many surfaces over the last 20+ years.
Now, depending on the level of overspray, you might be satisfied with the results achieved using a 3-M Clay Block and their clear liquid spray polish.
Use a soft rag and liquid polish to gently remove the foam splatters. Spritz' the area with polish and "Gently" start rubbing the area with the clay block. This will produce decent results.
IF the damage is worse, or you are still plagued with "Spots", then your next approach (much more aggressive) may be needed.
Once you have clay blocked the area, use 1200-1600 grit "Wet" sand paper with cloth backing. VERY GENTLY, with the liquid polish; wet the surface and sand the affected area. Follow this process with a polishing compound. Like that from DuPont.
Remember; doing any of the above could make the tub look much better. If you still aren't satisfied; There are people that can Re- gel coat the finish. That process may cost as much as a tub, but may be cheaper than the cost to R/R it.
Good luck.
Dave
You can use mineral spirits to remove Liquid Nails from the surround of a fiberglass tub and shower. You can also use Goop hand cleaner or even Vaseline to loosen the Liquid Nails.
Hi, my husband sealed our bath and got some sealant right in the bath. I removed it very easily with a facial wipe that I remove make up with. Hope this works for you too.
Depends on the glue. Scrape most glues first with a wood spatula, then try using Goo Gone.
Liquid Nails
use aliqid nail remover
dish washing liquid you need to use a lot
Ammonia poured in-between the seams should dissolve the liquid nails.
No, Liquid Nails will not stick to joint compound
I read this on another forum somewhere: Try using a small piece of fishing line, tie the ends around something, not your fingers, and use it like dental floss. Put the fishing line on the marble surface and try "cutting" the liquid nails like that, to remove it from the marble. Also you might try to apply a small amount of heat with a hair dryer. Liquid nails makes a "remover" product, which may or may not work on marble:http://paint-and-supplies.hardwarestore.com/50-278-adhesive-caulk-removers/liquid-nails-adhesive-and-caulk-remover-103697.aspx In general, the following warning probably applies to all Liquid Nails adhesives:Product may stain marble and granite.http://www.liquidnails.com/products/product.jsp?productId=48 Might need to search for tips on how to cover/mask/remove stains on marble...
Me
No. Liquid Nails is poisonous, and it'd kill you if you tried it. Plus, I don't think it would actually work.
Easy. If the nail glue says it can get removed by acetone buy a acetone nail varnish remover
liquid that you use for acrylic nails
COCA-COLA
Iron nails are a solid