0
This information can be found in your owner's manual. If you do not have one, you can obtain one from your dealer or a salvage yard.
What else can I help you with?
How can you reset the 626 Anti-Theft system?
This information can be found in your owner's manual. If you do not have one, you can obtain one from your dealer or a salvage yard.
Does the 1994 Mazda 626 have a anti-theft alarm?
How do i change my 1994 mazda 626 alternater
How do you start a 2002 Mazda 626 in anti theft mode?
check the battery condition, clean terminals, connect after 15 min.
How do you disconnect the stock anti-theft system on a 1993 Mazda 626 ES?
My Mazda is a 94. There is a black switch near the hinge on the driver's door about 6" from the floor board in front of the fuse box. The down position turns it off.
How do you reset the ABS light on a 2000 Mazda 626?
You can reset the ABS light in a 2000 Mazda 626 by unplugging the battery cables. You can also reset it by connecting a diagnostic tool to your car.
Where is the fuel pump reset switch on the 2000 Mazda 626?
There is none.
Where is fuel reset button on a 1999 Mazda 626?
The fuel reset button for a 1999 Mazda 626 is located inside the trunk of the vehicle. It will be on the left side close to the outer left tail light.
How do you reset check engine light on a 1997 Mazda 626?
Go to Advanced Auto. They should be able to.
How do you remove the heater core from a 1995 Mazda 626 1 liter engine?
You will need to drain the anti-freeze from your 1995 Mazda 626 cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
Does the 1987 Mazda 626 have a reset button if so where is it located?
Was wondering the same.. for a Fuel injected 1987 Mazda 626 non-Turbo According to a Mazda dealer I just called. There is no reset switch. The Fuel pump is located in the gas tank. and the Pump Relay is on the firewall of the passenger side. Regards, Yanek What do you want to reset? "Check Engine" codes can be reset by disconnecting the battery for 5-10 minutes.
Where is the fuel pump reset switch on the 1996 Mazda 626?
It should be located in the trunk on the drivers/passengers side.
How do you reset computer in 1998 Mazda 626?
To reset the computer in a 1998 Mazda 626, you can disconnect the negative battery cable for about 10-15 minutes to clear the system's memory. After reconnecting the cable, start the vehicle and let it idle for a few minutes to allow the computer to recalibrate. Additionally, you may want to check for any error codes using an OBD-II scanner if the check engine light is on. Remember to ensure that the radio and any preset settings are noted, as they may be lost during the reset.
