0
This depends on what oil sensor you are asking about.
The oil pressure sensor light on the dash will light up every time on the dash just before you start your car and go out as soon as the car starts.
If you mean your oil level sensor then you need to turn your key on, DO NOT START THE ENGINE!!, while the oil is drained durring your next oil change. If you pay a quick lube place then warn the person you wish to do this!
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is the best oil for a 300zx?
AMSoil works great.
What oil is best for a 1996 300ZX?
I use AMSoil, works awesome.
Where is the sensor for the oil gauge on a 1986 Nissan 300ZX?
It is on the passenger side of the block, below the exhaust manifold and next to the oil filter. It is a covered by a bell shaped rubber boot with wires coming out of it. Steve There may also be a oil temperature sensor if you have a turbo model , It is on the oil pan....
What if your oil change indicator no longer works on 2004 impala?
change the oil pump sensor.
How do you tell if the problem is oil pump or oil pump sensor on a 96 Grand Cherokee limited?
Remove oil pressure sensor and install a manual gauge
How do you tell if oil pump Is bad or is it the sensor?
You can pressure test with a gauge using sensor location
Oil pressure gauge in dash works some time and then dont a beep sounds?
It will be a oil pressure sensor
Can you use synthetic oil in 300zx?
Yes
How many quarts of oil for 1987 Nissan 300zx?
5 quarts of oil
How do you tell if the problem is oil pump or oil pump sensor on a 2002 misubishi lancer?
You didn't say what the problem is. But if you question the sensor, replace it, it probably cost lest than $20.
How many quarts of oil does your 1986 300zx turbo take?
You should put 3 quarts of oil in your 1986 300zx Turbo and then let it run for 30 seconds. After that, check the oil level and fill it until the oil on the dipstick is level with the H.
How does an oil pressure gauge works?
Most oil pressure gauges operate by a varying voltage. The oil pressure changes the resistance in the oil sensor, causing the gauge to change readings.
