how can i test iron parts in water by filteration method using sequestering agent
In solution, the salt will be dissolved in the water, the sand and iron will settle to the bottom of the container. Separate out the water, evaporate the water and the salt will remain, separate the sand and iron filings with a magnet.
there is 40000000 iron parts
There are three main working parts Heating element, sole plate and pressure plate are the working parts in electric iron. These three parts are same in even in automatic electric iron.
Iron doesn't contain water.
The minerals within a rock that contain iron, such as iron oxides or sulfides, are the parts that can undergo rusting when exposed to oxygen and water. This process results in the formation of rust or iron oxide on the surface of the rock.
Use a magnet to separate the iron filings. Add water to dissolve the salt, then use filtration to separate the sand from the solution. Finally, evaporate the water to recover the salt.
Iron filings do not dissolve in water. They are small pieces of iron that are insoluble in water and will float or sink in water rather than dissolve.
try baking soda and water made into a paste and scrubbed on the sticky parts...
cords
To remove calcium deposits in an iron, you can mix equal parts of white vinegar and water, pour the solution into the iron's water reservoir, and then turn on the iron to the highest steam setting. Once the iron is heated up, press the steam button to release the solution. Repeat this process until the calcium deposits are loosened and flushed out. Remember to flush the iron with clean water afterwards to ensure no vinegar residue remains.
Iron filings can't be dissolved in water, but, over time iron filling in water will rust away.
working of iron box