I have seen this on discovery channel once, it seems they used simple pulleys for this, and even the man power was big enough to handle the situation.
Slave labor.
The most probable way is a ramp whether it was one long continuous ramp or one that spiralled around the sides of the pyramid is a matter of conjecture. The ramp was built from waste quarry material bound together with clay. The stone block was placed on a sledge and dragged up the ramp by a gang of slaves.
The most likely method was a ramp. Whether it was one long continuous ramp or one that spiralled around the sides of the pyramid is a matter of conjecture. The ramp was built from waste quarry material bound together with clay and probably laid with wooden planks. The stone block was placed on a sledge and dragged up the ramp by a gang of slaves pulling on ropes attached to the sledge.
The Ancient egyptians got the granite block for the pyramid up by using internal ramps. In other words, ramps inside the pyramid. The grand room was used to hold a counterweight pulling the kings large burial chamber blocks up a small ramp.
they probably used the crane to carry it and lift it onto the pyramid
they got mud and shaped it. then they had the slaves to pull the blocks with ropes
Houses and apartment blocks, same as you.
they made blocks of mud and laid them in the sun to dry
they had cliffs of granite in which Egyptian people cut out their blocks from to buit the magnificant pyramids there are today.
they built a ramp up which the blocks were dragged to the working level.
Well, the ancient Egyptians would travel to a place pretty far from the building site where Giant blocks of limestone would be cut and shipped to the building site. There, the blocks would be shaped and pulled up the pyramid using dirt or wooden ramps. The pyramids contained about two million blocks! It required the work from ten to thirty thousand workers to complete it in twenty years!
Some scientists believe that they used thousands of slaves to lift the stones for the pyramid. The Bible mentions the Egyptians having slaves that later became the nation of Israel.
The egyptians wanted to use them in the building of their temples.
Yes it was, The Egyptians actually carried huge blocks of it to higher floors using a lift... it took Years for them to carry all of it. The reason they used Limestone was because Egypt is full of it...
The Egyptians used big blocks of rock
Houses and apartment blocks, same as you.
Two words, mechanical advantage.
It is because Egyptians were smart enough to make stone blocks. But even if they used sand, it would be destroyed by the next day because of natural forces.
they carried them up with their muscles
I found out it helped the Egyptians hammer the blocks into place.
They would rest their heads on their stone blocks then close their eyes.
they made blocks of mud and laid them in the sun to dry
Simply changing the suspension spacers, blocks and springs can be a lift that any toyota owner can afford.