It very much depends on whether you have enough hair left to adhere a clip to but the common practice is to either use a bobby pin to attach the toupee to your real hair underneath by sliding the clip through the mesh of the toupee. Alternatively you may wish to attach some toupee clips by hand (simple needle and thread job) to ensure the toupee will clip into your real hair. Another important factor is the fit of the toupee; if the fit is bad on your head it will never sit correctly.
Friction will cause heat, so you will slide and have a warm behind but friction will also slow you down on a slide
when you're going on a slide you are being pulled toward the ground so it would be gravity.
i believe so.
They work like hoses with a slide attached them. the water comes out the top of the slide and makes the inside of the slide slipery so you can "slide" down them.
well the two natural enimies on the playground are the slide and swing but the slide has another natural enimie the butt the butt slides down the slide wich makes the slide weaker than the swing so the swing is stronger.
The snapper arm, is the long thin stick thing, right? Ok then. You attach that snapper arm, to the little semi-curved rectangle, the small one. So when you pull the snapper arm across the mousetrap, it hits it. You just slide it in there, with the more hook part facing up. But you have to kind release the bar you pulled down, just slightly so that the snapper arm will stay in place.
if you do not hold your trumpet so the slide is diagonal to the ceiling, it won't slip. Also if your slide is too wide it will slide no matter what unless you tighten it with another piece of metal
When using the term of the question, that being "current slide" it can be used accurately in several ways. Basically it means "down turn". So if the topic is the economy and the economy is experiencing trouble by a loss of growth, or in fact there is negative growth, the economy is in a down slide. When speaking about an industry in the economy, for example automobile sales, then it can be said that the car industry is in a down slide.
so it goes down slowly, ie so it doesn't flatten the specimen to fast.
Potential energy. Potential energy is energy due to position of an object. So as he goes down the slide the potential energy is being converted to kinetic energy until he reaches the bottom.
Gravity is the force that is pulling you down. However, friction is acting against gravity to keep you in place, since you are rubbing against the slide. So the quick answer would be friction.
Is the engine and triple? If so they should hook up behind the carbs. There should be a barb sticking out that they slide on to.