Acura Integra

How do I change the brake light on my 1997 Acura Integra?

123

Top Answer
User Avatar
Wiki User
2014-09-17 23:41:38
2014-09-17 23:41:38

The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The brake light fuse on a 1995 Acura Integra is located inside the cabin of the vehicle. It is on the same circuit as the dash and hazard lights.

User Avatar

The 1991 Acura Integra brake lamp number is 2057. See sources and related links below for a picture and more information.

User Avatar

brake lights won't go off 1995 acura intergra

User Avatar

On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.

User Avatar

There is a sensor in the top of the brake cylinder where you put in the fluid. Replace it and the light will go away.

User Avatar

You will need to change the brake light switch. The brake light switch can be found below the dashboard on the drivers side.

User Avatar

The Integra uses a dual-filament bulb in the tail light, which has one contact for the running light (the lights you turn on at night) and another brighter one for the brake light (only goes on when you press the brake pedal). You have replaced the bulb with the wrong type. You will need a 2057 bulb for the Integra.

User Avatar

When there is erosion in the break light assembly it will do this. The wiring to the break lights may also be grounded out.

User Avatar

my 95 integra has a problem with the brake light located on the hatchback. I haven'y figured out what is causing it , but I have located it and it appears that something is loose inside that brake. Should figure it out here soon.

User Avatar

i am pretty sure there are no daytime running lamps on a 90' integra...

User Avatar

When changing the lights on a 1995 Acura Integra remove the dash on the center console and pull it off. Remove all the accessories and reach the old bulbs. Replace the bulbs.

User Avatar

most likely because you have no oil in your engine check it i change the oil i went to mechanic he check the oil but light showing .

User Avatar

you may have air in the brake line. bleed all the brakes. if the light still comes on intermittently go next to bleeding the line at the master cylinder.

User Avatar

The easiest way to reset the check engine light on a 1995 Acura Integra is to unhook the battery for a few minutes. If the light is still on after hooking it up again, there is probably still a problem that needs to be fixed with the engine.

User Avatar

If an Acura Vigor brake light is not working there are likely two reasons. One is that a fuse is blown and the other is that the bulb is blown. It could be both.

User Avatar

The parking lights on a two-door 1990 Acura Integra hatchback are located in between the headlights and the blinker lights. Replacement requires a size 3652 parking light bulb.

User Avatar

what do you have to do to change the center brake light

User Avatar

On the left side of the brake underneath the dash

User Avatar

The brake light failure sensor on a 1997 Acura 2.2 cl is located on the rear of the car. It is on the back of the left rear lamp assembly.

User Avatar

drivers side behind the fuse box in the inside of the fender wall

User Avatar

Have the same problem with '95 Integra; horn and stop light fuse goes repeatedly Checking the brake lights sockets wiring, hoping its there then the switch on the brake pedal then (groan) start looking at the internal wiring

User Avatar

On the break pedal assembly, it's kind of hard to get there but it's a little black button. When it's pushed in, the lights turn off and when it's depressed, the lights turn on.

User Avatar

how to change a brake light on 2002 Nissan altima


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.