follow the top radiator hose to the top of the motor and that will be where the thermostat is you must do this when the engine is cold or you will get burned. you also need to replace the gasket. dont over tighten the ears on the houseing or you will break it. make sure you put the same temp back in that you take out or you a/c or heater will not work right.
have u checked to see if u have a bulb blown. this will change the resistance on the blinker and make it blink faster
Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine
To change the thermostat in a 1992 Toyota Previa, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant, then locate the thermostat housing, which is typically near the engine block. Remove the housing by unscrewing the bolts, take out the old thermostat, and replace it with the new one, ensuring the rubber gasket is properly seated. Reassemble by reversing the steps, refill the coolant, and check for leaks.
Its right below the alternator. You have to remove it in order to get it out.
Remove the water supply hose from your 1992 Chevy thermostat housing. Remove the thermostat housing retaining bolts. The thermostat can be lifted out. Reverse the process to install the new thermostat.
Follow the top radiator hose back to the engine, the part that is at the end of the hose (engine side) is the thermostat.
follow the radiator top hose back to engine the thermostat is there under that domed connection
How do you change oxygen sensor in 1992 Toyota corolla? Is there a model engine 4A-FE without a oxygen sensor?
Look in the removable housing at the engine end of the upper radiator hose
under the alternator.... the lower hose going to engine
Every time you change the coolant.
The thermostat on a 1992 LeSabre should be inside of the top radiator hose inlet. You can easily change it by removing the top hose and water inlet.