0
How do I fix my Atwood trailer jack which is jammed and will not go up or down?
Wiki User
∙ 15y ago
First make sure that the outer tube and the inner tube groove are lined up. Sometimes these jacks get twisted and they are out of alignment. Next if it is a side wind jack then you have to check and make sure the gears are in good working order, they may have to be replaced.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
When was Jack Atwood born?
Jack Atwood was born on February 27, 1908, in USA.
When did Jack Atwood die?
Jack Atwood died on January 5, 1984, in Maine, USA.
When is a trailer most likely to jack knife?
On slippery, slick roads.
Difference between hi power and vip barker trailer jack?
limit switch in the hi power.none in the vip.this stops the motor at the end of the travel whether up or down
When operating an electric pallet jack before entering a trailer that is not is not attached to a tractor always make sure that answer it?
when operating an electric pallet jack before entering a trailer that is not attached to a tractor always make sure that answer it
What is the song in the movie trailer quicksilver?
Smilin' Jack Casey by Tony Banks
What is the name for the small wheel in front of a trailer that is used to raise and lower it?
a jack
What actors and actresses appeared in Trailer Trash - 2005?
The cast of Trailer Trash - 2005 includes: Tim Gato as Jack Carrie LaChance as Charlene
How do you hook up a load stabilizing trailer hitch?
hook trl. to hitch then jack up trl. to desired ride level then hook and bind the chains to a snug fit (not to tight not to loose then let jack back down the truck and trl. should be level.
What do I need to hook-up under the hood There is no power to the center pin for the trailer plug at the bumper I am trying to energize my new electric trailer jack.?
The center pin of a seven blade trailer plug is for reverse lights, not power. What type of truck is it? What trailer plug do you have...
When unloading a trailer that is not attached to a tractor with a forklift what should you do?
If it's a trailer with sliding tandems, ensure that the tandems are slid all the way to the rear. Then, you place a dolly jack under the front of the trailer and raise if up to the bottom of the trailer. This prevents the trailer from pivoting on the landing gear and tipping forward under the weight of the forklift.
Jack fell down and broke his what?
Jack fell down and broke his arm.
