I suggest finding a dealer in your area or checking a phone book, many people will charge you for this much info and step by step directions. I suggest calling a boat dealer or to find books with this info.
This problem is caused by disc brakes that have a fluid leaking from the calipers. You can buy loaded calipers an install to the car to fix the problem.
If the brakes are disc brakes then try opening the bleed screws on the calipers and see if the pressure releases if not then remove the calipers and replace because the piston is probably frozen or you can try pushing in the piston with a c-clamp,if that doesnt work replace the calipers as noted. If the brakes are drum brakes then check your brake cylinders to see if they are leaking if so you can usually rebuild them if not then replace them and bleed your brake system to get brakes back to normal, you can also make sure your drum brakes are adjusted correctly.
no
Be sure to change both front brake hoses. I didn't and my calipers would lock up.
calipers
I am working on this myself right now. I have replaced the master cylinder, lines, shoes, and calipers. The problem persists. I am going to try sanding and lubing the ways on the calipers today. There is nothing else to fix. I found an article in a Dodge forum that suggested this in the most detailed fix i have found.
If pads are bad you have to replace it, but it sounds like you have problems with calipers. Either you have to clean calipers or replace it. Check break fluid level. Check the breaking system, you might have some air in there.
You can buy a kit to rebuild the calipers. It is simpler and easier to buy rebuilt calipers.
No.
The calipers or wheel cylinders are bad.
Yes. If your question is regarding the operation of the calipers. They do operate in the same manner as the front calipers.
The calipers are stuck, or they are cheap brakes, or somebody got oil or grease on the brakes and disks.