Should be the same as my 2001. Use a small screwdriver (Torx 15 I think) to remove the screw holding the orange unt to the car. Then swing out the entire orange unit starting at the end that moves freely near the screw. Twist out the socket, replace the bulb (mine was a 24 bulb) then reverse everything. One time the bulb was OK but the socket rusted out. I got a replacement socket with wires and heat-shrink cover (no bulb) for about $25 and did it myself in 10 minutes using butt-end connectors. Good luck.
Remove the socket containing the bulb from behind the bumper. Twist the socket 1/4 turn counterclockwise and pull the socket out.
15mm
how do you replace front passenger window switch on a 2000 chev malibu
If it is like mine you have to remove the whole fixture to get to the headlight and park light/turn signal, but it not really that hard I think you just need a 10mm socket and wrench but I might be off on the size of the wrench.
Remove the spark plug wires from your 2004 Chevy Malibu spark plugs. Remove the old spark plugs with a 5/8 deep well socket, by turning the socket to the left. Reverse the process to install the new spark plugs.
Just stick your arm under the bumber. The bolt is in a twist lock socket like the headlights.
To change the front blinker bulb on your 1986 Chevy Celebrity simply reach up behind the bumper and unplug the socket from the fixture. Replace the bulb in the socket and plug the socket back into the fixture.
you push in front of lens into bumper, and than slide lens into bumper and it will pop out, then change bulb by pulling socket out.
It requires a special socket and it is only good for oxygen sensor replacement. Buy the socket and unplug the sensor ,install the socket and remove the sensor.
* Raise the car and suitably support it on jackstands * From below you can access both the turn signal and side marker lights * The side marker bulb holder pulls straight out of the socket and the turn signal bulb holder must be rotated to remove it
1. Unplug from voltage. 2. Remove lamp. 3 Remove socket from stand. 4. Replace old socket with new socket.
HELLO, I WAS LOOKING FOR THE SAME ANSWER TO THIS QUESTION BUT I FINALLY FIGURED IT OUT. FIRST, YOU HAVE TO TAKE THE COVER SHEILD ABOVE THE HEAD LIGHTS OFF AND THEN USE A 13MM SOCKET TO REMOVE THE TWO BOLTS THAT HOLDS DOWN THE HEADLIGHT ASSEMBLY, YOU SHOULD BE ABLE TO REMOVE THE THREE CAP SCREW USING A 11MM BOX WRENCH. TWIST LIGHT SOCKET 1/4 TURN AND POP OUT CORNER MARKER LIGHT UNIT AND REPLACE. . KINGT