Want this question answered?
Unplugging the coil wire and not grounding it, yes that can damage the coil.
You remove the 10 mm bolt on the coil pack and unplug the coil. you may have to remove an hold down too to get to #2 or #3 easy to do remove coil by pulling the coil pack setting aside use spark plug socket and a extintion your good
Pull each coil plug off one at a time while the engine is running... The coil pack that is bad will NOT have a difference in engine noise, but the ones that are good you will hear a slight decrease in engine noise when you unplug the coil and then plug it back up again... Hope this helps everyone!
testing the starter
Caution:Some models are equipped with an anti-theft radio.Before disconnecting the battery cable make sure you have the activation code for the radio. * Disconnect negative battery cable * Unplug the coil electrical connector * Unplug the spark plug wires from the coil * Remove the coil mounting bolts * Remove the coil assembly
unplug wires to coil.remove the 7mm bolt pull coil off.
It does not have spark plug wires. It has a coil on each plug. You unplug the electrical connector, remove the hold down nut, and lift the coil off.It does not have spark plug wires. It has a coil on each plug. You unplug the electrical connector, remove the hold down nut, and lift the coil off.
A 2002 Jeep Wrangler has coil springs.
where is the 5 coil located on a 2002 Lincoln ls
Immortal Coil was created in 2002.
The Coil of Sihn was created in 2002.
Unplug unit and remove bolts?