Want this question answered?
there aren't any, so there isn't any.
The red needle points to magnetic north and the white points to magnetic south. The bearings tell what direction the next point is.
A clutch for an automotive air conditioning compressor is composed of three parts. the magnetic coil the pulley the hub the magnetic coil is mounted on the front of the compressor and nestles closely insid the pulley. the Pulley is mounted on the bearing mount extension of the compressor the hub is fastened to the end of the input shaft of the compressor. It normally sits slightly above the surface of the pulley When current is introduced into the coil, the coil becomes magnetic. Then the magnetism is transferred into the pulley and it pulls the hub down to engagement.
a magnetic compass shows the direction of magnetic north and bearings from ita compass is also a drawing utensil in design and technology that you can use to draw accurate circles. This has been improved by Harriet webster
Your question is very vague...is it how to remove bearings or how the replace bearings or how to size new bearings on an old worn shaft???? And what bearings??? There are several hundred bearings on a car...one kind of bearing on fishing reel...for or five bearings on a bicycle
what is the meaning of compressor.and how does compressor work.and how many types of compressors
Same way a non rotary compressor works
the compressor is coupled with engine.when the engine runs at 1000 rpm ,the compressor also will work at that rpm ,so that is air is compressed in tanks and it is used for applying.
If the compressor has stopped running altogether the AC will not work.
yes but if the compressor does not work there is no reason for it.
It is possible the air compressor is bad. You will need to replace the air compressor, so the air will work again.
Inefficiencies in the compressor of a gas turbine cycle increase the back-work ratio and decrease the thermal efficiency of the gas turbine cycle, since they increase the compressor work.