You can not successfully clean an oxygen sensor. You need to replace it.
Clean it using steel wool.
An abs sensor, can get metal shavings stuck to it, can brake clean, but normally if you have a fault it needs to be replaced.
Remove it carefully, spray the sensor wire with brake clean or alcohol, do not touch it, reinstall.
If you have access to the sensor you can spray brake cleaner on it to clear the debris.
Faulty TDC Sensor, All it will need is cleaning. Take it out clean the tip of the sensor so it is clean and shiny again, also clean the electrical connector.
The speedometer sensor is lovande On rop tight of the tranny, loosen The vilt and lift The sensor up, there should be a O-ring so be careful when you lift it up! then sand The sensor genre and clean it carefully. Done!
no
It can not be cleaned. Trying to clean it will mess it up.
It is not clean able, if bad it needs replaced.
Common results point to "You can not clean an O2 sensor, it must be replaced"
Yes. remove it and clean it with a towel. also clean the hold it monitors in the manifold