You can either spray carb cleaner down the tube line that goes to it which is the metal tube next to the throttle plate. Or clean it thoroughly by taking of intake manifold which is a pain, taking AIC valve apart and spraying and cleaning it with carb cleaner!
it will fit but you need to modify the mounts.
Yes, late model bumpers will fit on 89-90 240sx
I have a 91 240SX and had a similar issue, my Fuel Pump had to be replaced.
The IAC is located on the throttle body. Simply unplug the dirty IAC and clean or replace the IAC.
Yes, even though the front bumpers are different the fenders are the same
The Idle Air Control (IAC) valve on a 1995 Nissan 240SX is located on the throttle body, which is situated on the intake manifold. Specifically, it can be found on the side of the throttle body, attached to the intake system. To access it, you may need to remove some components for better visibility and reach.
Full Synthetic 5w-30
no, that's good. If it doesn't die, then you're in trouble. You need to clean or replace your IAC
0.044 (In thousandths of an inch) as specified by auto zone for my 1995 240SX SE (KA24DE)
no the civic engine is a transaxle not rw
The Haynes Manual (copyrighted) gives no instructions for the cleaning of the IAC, only its replacement if defective.
you might check your IAC valve (idle air control valve) check your TPS