To remove the door panel on a 1988 suburban, first remove any light lenses and stereo speaker covers in the door. Then, gently pull at the corners with a screw driver to remove the larger panel.Ê
remove the inner door panel, you can access the bolts from the inside of the door.
The 1990 Chevrolet Suburban door panel is held in place with 14 retaining clips and two screws. Remove the screws, that can be found near the door handle. Pry outward on the retaining clips to remove the door panel.
To remove the door panel you will need to find and remove all screws. Once you have taken out the screws you will need to gently pull the panel away from the door.
use your mom
remove the inside door panel and go from there.
Replacing a door panel in a 1988 Ford F 150 is very simple to do. The only tool needed to remove the door panel is a Phillips screwdriver. You will need to unscrew the screws on the door panel only to remove. It should take less than 10 minutes.
Removing the front door panel can be tricky. Remove the screws in the armrest, remove the bracket pin the wood trim, remove the armrest, remove the leather strip, disconnect any wires, remove the brackets and screws in the door panel and pull gently on the panel to remove it.
Remove door panel and replace latch mechanism
Remove the door panel and you will see the window regulator. There should be two or three bolts holding the door panel on, pop the window switch out and use a long flathead screwdriver to pop the panel out of the calmps securing it to the door
Using a screw driver, remove all the screws and clips from the panel, and gently pull the panel away from the frame. Remove any wiring connectors between the panel and frame, then pull the panel off the rest of the way.
You need like an 8mm socket to get the srcrew just under arm rest and the one on the lower right of door....you then pull upward and disconnect switches before you cmpletely remove panel.
2-3 SCREWS ON DOOR HANDLE AND UNDER POWER WINDOW TRIM PIECE, THEN LEFT STRAIGHT UP TO REMOVE