Want this question answered?
You can find it attched to the condenser air quide. If you want to get to it, you will have to remove the glove box compartment.
The resistor is located on a duct behind the glove compartment and the glove compartment back.
You can find behind the glove box compartment.
On a outlander 20003 you need "carefully" to remove the left plastic pin inside the glove compartment, then you can easily unhook the right pin which is attached to the compartment. Drop it all way down and remove the compartment.
You can find behind the glove box compartment. The box has to be removed if you want to change the filter.
yes it will be i got the 17 inch wheels for my 2003 galant and they fit like a glove.. not the OJ glove lol
Not sure this is the approved manner but this is how I perform the change. First remove the glove compartment. This involves removing 4 screws from inside the glove compartment. Next remove the lower trim piece ( below the glove compartment), this involves removing the fuse cover and then removing 2 screws. This trim piece should then pull out with a little light pulling. Once this is out remove 3 screws holding the glove compartment in place. Remove the glove compartment. There is a metal trim piece that held the glove compartment in that you remove with a couple of screws. Then remove the filter cover (it snaps right off). Remove and replace the filters. Reverse the procedure to finish.
how do you remove the glovebox in an rx300 lexus 2002
the headlight relay is above the glove compartment. remove the glove compartment , look to the upper right
The flasher module on a 1994 MK VIII is located to the left of the glove compartment. To access it, you must remove screws that hold the the glove compartment door hinge. After you remove the glove compartment, the flasher is mounted on a dash support beam to the left side of the compartment.
Glove Compartment
Under the glove compartment. Need to remove the glove compartment to gain access to the computer