* Disconnect the electrical connector from the IAC valve * Remove the two IAC valve attaching screws and withdraw the valve from the IAC housing * Clean the sealing surface and the bore of the IAC housing with a shop rag or soft cloth to ensure a good seal * Postion a new O-ring on the housing.Lubricate the O-ring with a light film of the engine oil * Install the IAC valve and tighten the screws securely * The remainder of the installation is the reverse of removal
The idle control valve for your 1995 Nissan Maxima can be found on top of the engine. The idle control valve will be attached to the back of the injector fuel pump.
The IAC valve is mounted on the upper intake plenum (manifold)
The idle air control valve controls the neutral idle of the 2001 Honda Accord. A faulty idle control valve leads to an erratic idle. To replace it first locate the valve on the intake manifold. Unplug the unit and remove the three bolts holding it to the manifold.
On idle speed control actuator is located on the front of the air intake plenum
on the right side of the throttle body
clean or replace your idle air control valve.
The idle air control valve on a Volvo S80 is located on the intake manifold. The valve controls the rate at which the engine holds an idle.
== ==
Attached to the intake manifold
Some later models, 2001 onwards, don't have an idle control valve. The function is designed into the Electronic Throttle.
Open the hood of the car and find the idle air control valve. The valve is located on the Gran Marquis' throttle body. The idle air control is a cylinder with a wire connector plugged into it. If needed, refer to your repair manual for an exact diagram. Read more: How to Clean the Idle Air Control Valve in a 2001 Grand Marquis | eHow.com http://www.ehow.com/how_7649344_clean-valve-2001-grand-marquis.html#ixzz1eqCpBmRx
Maxima Running RoughTry replacing the Idle Air control valve! I am having the same problem, and cannot find anyone who knows where it's located so I can take it off.UPDATE: The Idle Air Control valve is located underneath the throttle body. Remove the throttle body, turn it over, and voila! There she is.