my front headlights dont come on all the just one if i slam the trunk will come on what do i do
You have to take off the plastic shrouds in the inside of the wheel wells. There are about 4-5 plastic "push-in" screws (or snaps) that you have to pop out, then remove the shroud, and when you look into the wheel well you will be able to see the marker lights. Pop out the bulbs and replace but be careful because often times the bulbs have shattered and you'll cut yourself. Good luck.
The side marker bulbs on a 2002 Buick LeSabre are replaced by removing the retaining screws and disconnecting the wiring harness. The old bulb can then be removed and a new bulb put in its place.
It should be the same type of bulbs that are in the side marker lights. They should be #194 bulbs if memory serves.
how do you replace side marker light on 2008 chevy trailblazer
I've replaced the front marker bulbs. Take a flat smallish screw driver, and insert it behind the yellow lens. Carefully pop it out. Move the lens towards the rear, to unhook the 2 plastic tabs. (don't force it or you'll break them off!!) The bulb is now exposed. Pull it straight out, and replace it. You might try wiggling it abit first. It might just be a poor, corroded contact.
where can I find a video on how to replace a 2006 rear SIDE MARKER bulb>
How do you replace 2001 Mercedes c320 front marker light
The timing chain is designed to last the life of the engine.
no
Are you talking about the side marker bulbs on the front bumper? These bulbs should have a access panel from behind them. Look in front of the tire, on the front part of the platic wheel well liner. Should be a small hole that has a release tab, press that tab to release the side marker lens. Then you can just pull the old bulb out, and re-install.
To replace the bulbs in a 1997 Acura safely prop the hood open. Locate the front headlights and remove the old lights. Replace the bulbs.