turn ignition off. Press and hold small black plastic knob which is next to digital mileage display (Next to rev counter/speedo clocks etc.). Turn ignition on so all dash warning lights etc. illuminate whilst keeping button held down. The INSP message and little spanner should now flash too, and then it will go out and a line of blanks will show when done/reset (----). Turn ignition off and it will now be re-set.
what does INSP mean? this came out in my 1998 Audi A4 1.8T.
service due
For oil press and hold the right hand button on the cluster - oil will appear in the display - release right hand button then turn left hand button clockwise until ----- appears. For insp press and hold right hand button - turn on ignition - release button then press and release button again - insp will appear in the display - turn left hand button as before until ----- appears. note: if you're clearing the insp service sometimes it's necessary to clear the oil service afterwards (if it wasn't done at oil service) For oil press and hold the right hand button on the cluster - oil will appear in the display - release right hand button then turn left hand button clockwise until ----- appears.
i think its somethink to do with the service is due
INSP mean "Inspection" or in other words "The car needs a service." IF it has been serviced recently take it back where it was serviced, and ask them to finish the job by reseting the service light. If it has not been serviced, get it serviced.
Switch ignition OFF, Press and hold button at speedo. After approximately 3 seconds the letters "INSP 0" will appearin the display. Continue holding button at speedo,depress brake and switch on ignition ON. The letters "INSP---" will start flashing in the display to be replaced after approximately 10 seconds with the message "INSPxxxx Km". Release button at speedo and brake pedal and switch off ignition.
This simply means that a service is due in the near future.
To reset a T4 Service indicator. With ign off, press and hold trip mtr butto. Switch ign on and release the button. If only "insp"is in the display, turn minutes knob to right on the clock, "service ----" should now appear in the display. Turn off ign and service is reset. If "insp and Oil" are shown in the display, get to insp by toggling the trip mtr button. follow above procedure, but don't yet turn off the ign, press the trip mtr button again and "oil" should appear, again turn the minutes knob to the right and "service----" will appear. Turn ign off and service is reset. Works for me on my 2000 T4.
To reset a T4 Service indicator. With ign off, press and hold trip mtr butto. Switch ign on and release the button. If only "insp"is in the display, turn minutes knob to right on the clock, "service ----" should now appear in the display. Turn off ign and service is reset. If "insp and Oil" are shown in the display, get to insp by toggling the trip mtr button. follow above procedure, but don't yet turn off the ign, press the trip mtr button again and "oil" should appear, again turn the minutes knob to the right and "service----" will appear. Turn ign off and service is reset. Works for me on my 2000 T4.
Ernest Haigh has: Played Insp. Haigh in "Lost, Stolen or Strayed" in 1921. Played Insp. Haigh in "The Man Who Came Back" in 1921. Played Insp. Haigh in "The Girl Who Came Back" in 1921. Played Insp. Haigh in "Something in the City" in 1921. Played Insp. Haigh in "The Lady in Black" in 1921. Played Insp. Haigh in "The Stolen Jewels" in 1921. Played Insp. Haigh in "The Notorious Mrs. Fagin" in 1921. Played Insp. Haigh in "Belle of the Gambling Den" in 1921. Played Insp. Haigh in "The Prodigal Son" in 1921. Played Insp. Haigh in "The Case of a Packing Case" in 1921.
To reset Corsa D 57 plate do the following, put your foot on the brake pedal then press and hold the odometer button in. Wait until Insp 0 comes on the display, then switch on the ignition wait a few seconds. Now it should display Insp 19000 (depending on service interval). Release button and brake pedal, now switch off ignition. Next time you turn on ignition the Insp 0 should no longer show on the display. This did work for me.
Arthur Bell has: Played Insp. Lestrade in "The Resident Patient" in 1921. Played Insp. Lestrade in "The Empty House" in 1921. Played Insp. Lestrade in "The Tiger of San Pedro" in 1921. Played Insp. Lestrade in "The Noble Bachelor" in 1921. Played Insp. Anthony Jones in "The Sign of Four" in 1923.