0
What else can I help you with?
What are basketball equpiment?
ball= a rubber round ball that you use to shoot into the basket basket= a tall hole that lets the ball come through the hole net= part of the basket rim= the outside part of the basket
How do you refilling and reset HP 950 setup cartridges?
1. Look at the end of the cartridge for a plastic ball the is plugging up the filling hole. 2. Stand the cartridge on end where the plastic ball is facing up. 3. Put the "L" tool on top of the plastic filling hole ball and tap it with a hammer to knock the plastic ball into the cartridge. 4. Put the blunt needle onto the syringe and fill the syringe with ink. Black Cartridge will hold 20ml of ink, High Capacity Black cartridge holds 40ml. Color Cartridge will hold 10ml of ink, High Capacity Color cartridge holds 20ml. 5. Seal the filling hole with the rubber ball included with your refilling kit, by putting the rubber ball on top of the filling hole and press the rubber ball with the "L" tool until you feel it snap into place. Note: On your second refill you do not need to knock the ball into the cartridge. Just screw the ball remover half way into the rubber ball and pull it out. If you did not tear up the rubber ball you can use it again to seal the hole.
What do jem and scout find in the knot hole the third time?
Jem and Scout find a ball of twine in the knot hole the third time they visit.
Where can you find the rubber cap that plugs the fill hole for your Larin LJ4000 floorjack?
Advance Auto Parts
How do you install bowling ball inserts?
For plastic, urethane or rubber inserts, a hole is drilled the size of the outer diameter of the insert to be used. Care must be taken to factor how the span of the inserts are placed with where the holes are placed. After drilling has been done, the inserts are glued in. While thumb inserts can be replaceable, it's more common to drill a large hole where the thumb goes and a solid thumb insert is glued in the hole. The thumb hole is then drilled into the solid insert.
What is a small ball with a hole in the middle?
A small ball with a hole in the middle is probably a Bead.
What is the best way to clean a trackball so the mouse responds faster?
Remove the cap with the hole below the mouse, remove the ball and clean it, and clean the rolling cylinders that you will find inside the hole were the ball came from.
Where do you find garentiena's orb?
when you first see giratina and it goes into the black hole go behind the hole and there is a poke-ball. click on it and you get giratinas orb!
How do you fix a tiny hole in a four square ball?
To fix a tiny hole in a four square ball, start by cleaning the area around the hole with rubbing alcohol to ensure proper adhesion. Next, use a rubber patch kit that includes adhesive specifically designed for inflatable balls; apply the adhesive around the hole and place the patch over it. Allow it to cure according to the kit's instructions before reinflating the ball. Ensure the repair is secure by checking for any air leaks.
What is scoring on chipped ball knocking ball on green in hole?
The ball must be removed from the hole and placed in its previous spot. No penalty.
Can your nipple piercing hole get to big that the ball goes through?
It shouldn't; if it gets that large without your stretching it, the piercing might be rejecting.
Can you tee off with one ball and then switch balls on the fairway?
No, the ball you start the hole with is the hole you finish the hole with - unless of course you lose it.
