u dont hover the mouse on the bar
You can't as the censor code is etched into the video code for each frame, so if you want to remove it, you must get the uncensored original video.
You can't remove the watermark from the watermarked video as the watermark is embedded in each frame. You will need to keep the original, un-watermarked video.
Pong. The one with two lines on each side and a ball going through the middle.
Minnesota.
You can remove the dashboard from a Mitsubishi Triton by removing the retaining clips. There are 6 retaining clips. Two clips on each and of the dashboard and two clips in the middle.
open drawer, at front on the sides in the middle of the track is small screw on each side, remove and lift front off drawer out of track.
take tire off and look and see if u have 2 holes in middle across from each other, they are threaded,get 2 bolts about 1 and a1/4 inch long and screw them in even and the hub will come off
For each headlamp, Remove the two 15mm Bolts that have a six pointed star in the middle of the head. The glass headlamp will then slide forward and you can reach behind and remove the lamp unit.
you draw a line from the middle of an angle to the exact middle of the side exactly across from it. do this for all three angles. they should all meet at the exact center! :
Remove bottom of the license plate cover by slowly pulling outwards. It is glued with a HEAVY 3m tape. The top of the cover is different it has 3 hidden tabs across the top. Slide a flathead screwdriver down from the top of the cover and slowly work each tab out of its slot. There is on the upper left and right and one in the middle.
It depends on what type of video you are trying to embed in your website, but generally speaking you are going to use the <object> tag in combination with the <embed> tag in order to maximize compatibility across browsers. Each video format you want to embed uses slightly different settings.
First, remove the nut from the middle of the bumper, and then remove the nut from the the mounts at each rail frame. Then remove the nut or screw holding the bumper to the car at the area of the wheel. Remove the old bumper, put on the new bumper, and replace the screws in nuts in the reverse order.Ê