The tailgate cap is secured to the bed by two rows of plastic rivets. The rivets slide on individual tracks. Using a rubber mallet, firmly but gently(at first until you get the "feel" of the force needed), rap on the left(driver's) end of the cap. You are trying to slide the cap from left to right about one inch. You may then simply lift the cap off the bed, leaving all the rivets in place. Installing the cap is just the reverse of the removal. If you need to remove the plastic rivets for any reason, simply rotate them about one quarter turn and they come right out.
5000 lbs towing according to Honda and a 1500 payload cap so not bad!
Inside the distributor - remove the cap and you will see it.
Loosen the screws on the cap and there is a single screw holding the rotor to the shaft
You must remove the wheel because there are scews that hold it onto the inside of the wheel.
To change the distributor rotor on a1998 Honda Civic unplug the spark plug wires from the cap. Loosen the screws and remove the cap on the unit. Be sure to properly line the new cap on the distributor and install.
Inside the distributor cap. 3 screwes hold it down. Remove them, pull off the dizzy cap and you will see the coil.
Bit of a fiddle to get to but 1 remove rear pillion seat 2 remove rider seat 3 remove tank 4 remove rh cover plate at front of tank and radiator cap will be revealed (remove with care if hot!!!!)
To fill the brake fluid in a 2001 Honda Odyssey, you need to find the brake fluid reservoir and remove the cap. Fill the reservoir with the right amount of fluid and put the cap back on.
nope use vise gips and remove cap go and purchase a new cap and oring
two feet
In the distributor. Remove cap and it is the large black(in most cases) box with four screws and two wires.
Wait for engine to be fully cooled down. Take a magnet on a wand & #2 Phillips screwdriver and remove lock screw from radiator cap. Turn radiator cap counter clockwise until it rises into a loose position and lift it off.