1. Disconnect and isolate negative battery cable. 2. Remove accessory drive belt 3. Remove generator mounting bolts and reposition generator 4. Unlock and disconnect the electrical connector from the EGR valve. 5. Remove the 2 EGR tube bolts.
1. Install a new gasket on the EGR valve.
{| |- | 2. Position EGR valve to cylinder head and install the 2 mounting bolts. 3. Tighten EGR valve mounting bolts to 31 N·m (23 ft. lbs.). 4. Position EGR tube to EGR valve and install the 2 mounting bolts. 5. Tighten EGR tube mounting bolts to 13 N·m (115 in. lbs.). 6. Connect electrical connector to EGR valve. 7. Install generator mounting bolts 8. Install accessory drive belt 9. Connect negative battery cable.
|}
Just replace it, the sensor on the top of it is usually what goes bad.
where is the transmission fluid pressure sensor located o a 2005 dodge grand caravan
A Grand Caravan does not have a timing belt.
The EGr valve can be difrent and is in difrent locations on the various engines
How do I replace the heating coil in a 2006 Grand Caravan? I have no heat it only blows cold air.
Right front corner of engine, above alternater.
It could.
You unbolt the one you wish to replace and bolt the new one in.
yes
Front passenger side corner of the engine.
The 2005 Dodge Grand-Caravan has 12 valves.
The 2005 Dodge Grand-Caravan has a V6 engine.