Remove belt, remove crankshaft bolt with air impact tool, remove balancer pulley with a balancer puller. Then you will be able to get to it.
On front cover of engine, slightly above crankshaft pulley.
Begin by removing the rear engine cover from your 1997 Land Rover Discovery. Remove the crankshaft sensor wiring harness. Remove the crankshaft sensor retaining bolts. Reverse the process to install your new crankshaft sensor.
take out old one put in new one
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
location of crankshaft sensor on 1997 Infinity I30 is it on the engine or in the gas tank plz show a pic
That should be the Oxygen Sensor
To replace the crankshaft position sensor in a 1997 Lincoln Town Car, first disconnect the negative battery terminal for safety. Locate the sensor, which is typically found near the bottom of the engine, attached to the engine block near the crankshaft. Remove the electrical connector and the mounting bolt holding the sensor in place, then replace it with the new sensor and reattach the bolt and connector. Finally, reconnect the battery and start the engine to ensure proper operation.
right side of crankshaft pulley
It does not have a crank shaft sensor.
In the exhaust pipe
On a 1997 Ford Taruas I was just quoated from Ford Dealer 375.00 labor plus parts
the crankshaft sensor is located behind the harmonic balancer on the ft timing cover