Want this question answered?
its tym to service........ take d car 2 d nearest skoda authorised service centre
That's a fuel injected car, so you need to take it to a dealer/ mechanic with the right diagnostic equpment.
There is 3 round plastic caps on the top of the cover,1 at the back and 2 at the front. Pop these out with a screwdriver and there is a nut under each one. Take off the nuts, take out the dipstick and take off the oil filler cap and the cover comes off.
1990
Castrol 10W40.
There are several places one can take their printer for repairs. These places include The Printer Shop, A1 Printer Repairs, and the brand store of the printer you are trying to have fixed.
well i had 1.6 octavia to change the plugs in that i got a plug spanner that has a multi joint on the ,,plug end ,,the shaft had a T bar on it i had to cut off half of it ,so i could turn it without it hitting the inlet manifold,,take your time,, make sure the plugs go back in straight and the treads are clean,,,i got a long nosed pliers to take the ht lead off dont pull by the lead it will damage it ,,good luck,,
Apparently the skoda fabia uses synthetic oil, i had my service done yesterday and had to pay £20.00 extra for this oil, mines a 1.4yreg 8v.
Octavia 1: Left front door; -remove cover on door grip, take out 2 screws -5 torx holding the hardware -defect part is the plastic-parts holding the wire to the window. -with luck, and early repair, it can be all you need to do. -if not: remove motor, and drill out for removingen the shield over sprocket for wire -new wire need to be rolled on from one side, and minimum on other side. or then equal, with the lift in middle posision.
Printer Control Language (PCL)
how to take out battery case
you take care of it