You have to take the dash cover off. The blend door cable and swing arm are just under and in font of the defroster vent. You have to pretty much take the defroster vent out to access the cable and swing arm. This whole process will take a while as you have to take the center console out, the dash cover off, the passenger airbag out, and the dash off just to be able to actually work on the blend door.
But take the top dash cover off and look under the defroster vent and you will see two cables one is the position cable and one is the temp cable (connected to the swing arm on the blend door. You will then get an idea of how much you need to take apart to fix the problem. It also depends on how small your hands are and if you can work on the problem without removing everything else.
The blend door for a 2000 Neon is located behind the dash. The blend door controls the air flow for heat and ac.
how to remove a door lock cylinder on 2000 dodge neon
Faulty thermostat. Plugged heater core. Temp blend door malfunction.
on the driver side, open the door and on the side part of the dash board thare is a pop off door that will allow access to the fuses.
Thermostat stuck open. Replace! A low coolant level will also cause this problem. The blend door could be stuck also.
it is the pastic push button inside of the door jam,when it is pushed IN the light goes off,OUT the light comes ON.
Yes.
it is located on the side of the dash between the dash and the driver door
Click on the link to your right for instructions.
It is in the tank, tank has to be lowered to access. There isn't an access under the seat.
Behind the dash, connected to the blend knob and runs down to the HVAC housing at the front passenger of the cabin, also behind the dash. The blend door is inside the HVAC housing adjacent to the heater core.
A dodge neon does not have a heater valve. The inside temp is adjusted with an airflow control door inside the dash.