Yes.
Remove inside door handle and window crank handle, remove inside door panel, remove vent window and channel assembly, remove window.
To replace the window crank handle on the 1993 Geo Prism, first remove the interior door panel. Then, access the screw that holds the window crank in place and remove it. You can then remove the handle itself.
To remove the handle the inside door panel has to come off,with the window up.there is a small bolt insde and one at the end of the door by the handle take those two off and the linkage inside...yes you need small hands.
remove the window handle, remove screws from armrest, remove the inner door handle and the screw on the lower rear of the door panel, lift the panel upwards to remove from the slots along the bottom of the door.
You will need to remove the inside door panel. Remove the door handle retaining screws. Remove the linkage from the back of the door handle.
Remove the armrest, door handle, and window handle. You will need a special tool to get the window handle off. They're cheap and you can get them at any auto parts store. Remove the screws at the bottom of the door panel then CAREFULLY pull the retaining clips out of the door by sliding a screwdriver between the panel and door where the clips are (you'll find them at the front and back) it is VERY easy to tear the backing of the door panel when removing them, so be careful and patient. Slide the door panel up to unhook the top of it from the door. Remove the window regulator bolts and carefully slide the rollers out of the window tracks. Carefully remove the window from the top of the door. slide the window regulator out.
To take the window handle off of the 2005 Kia Spectra, you will first need to remove the interior door panel. This panel pries off of the vehicle using a flat screwdriver or a prying tool. Then, access the door handle by removing its cover and then remove the screw at the center of the handle.
Push the door panel in around the window handle and use a screwdriver or a piece of wire with a hook to pull the clip off....it's in behind the handle.
there is a small clip between the handle and door panel that u have to remove it is easy if u have a small pick to hook it with then to install just place clip on handle and push on the window regulator shaft.
If there is no faster head visible then it likely is attached with a clip on the backside of the crank handle. slip the handle between the handle and door panel to remove the clip.
Remove the inside door panel of your 1999 Chrysler Intrepid. Remove the window retaining clips. Put the window back into the window track. Secure the window with the window retaining clips.
First remove the Window Crank Handle. Then remove all of the screws you can find, 1 for the door release, 1 for the door grip, and 4 for the door panel. Pop loose all of the lower door area, and carefullyremove the door panel. Remove the plastic behid the door panel, SAVE IT!!. With the window all of the way down, remove the screws that hold the window in and remove the window. Revers to reinstall, being sure to locate the new window into the grooves for that.