Push the door panel in around the window handle and use a screwdriver or a piece of wire with a hook to pull the clip off....it's in behind the handle.
To remove an interior door handle from a Hyundai Excel, first, ensure the door is open and locate any screws securing the handle, typically found near the base or inside the handle itself. Use a screwdriver to remove these screws. Once the screws are out, gently pry off the handle cover, if applicable, and pull the handle away from the door panel, disconnecting any linkages or electrical connectors if present. Finally, remove any additional screws or clips that may be holding the handle in place.
Paint scraper with a bit cot out on the edge in the middle about 1.5 cm square then slide it behind the handle and wiggle the scraper a bit and the clip will just fall out the bottom
How do you remove front door Panel on Hyundai Excel 1999 to Rplace front door SPEAKER'S
I have come to the conclusion myself that the only way to remove the glovebox in a Hyundai Excel is .................................................................................................................get a hammer and smash it to bits
You don't
Dynamite
Take to the Mechanic .... LOL
Hyundai Excel was created in 1985.
I do believe that 91 and 94 are the same procedure. have to remove the door handle and the window handle. there is a clip that holds the window handle. There are three screws that hold the unit (window regulator)in place. You will have to get the window up and out of the carrier and, pull the unit out. put the new unit in and,place the window in the carrier but, make sure the window is at the full closed position (that is where you need another set of hands) then, you tighten up the screw in the unit. The window is seated at the full closed position therefore when you tighten the unit up is wont twist. when I got someone else to replace the window regulator they had that window in the down position and the new regulator lasted about 2 weeks and then broke again... thanks mr mechanic....grin
To fix the driver's side window on a 1998 Hyundai Excel, first check the fuse related to the power windows and replace it if necessary. If the fuse is intact, inspect the window motor and regulator for any signs of damage or failure. You may need to remove the door panel to access these components; ensure all connections are secure and replace any faulty parts. If the window still doesn't operate, consider consulting a professional mechanic for further diagnosis.
To get the radio code for the Hyundai Excel you need to request it from Hyundai.
Hi Try this http://www.carstereohelp.com/stereoremovalHyundaiExcel.htm