I do believe that 91 and 94 are the same procedure.
have to remove the door handle and the window handle. there is a clip that holds the window handle.
There are three screws that hold the unit (window regulator)in place. You will have to get the window up and out of the carrier and, pull the unit out.
put the new unit in and,place the window in the carrier but, make sure the window is at the full closed position (that is where you need another set of hands) then, you tighten up the screw in the unit.
The window is seated at the full closed position therefore when you tighten the unit up is wont twist. when I got someone else to replace the window regulator they had that window in the down position and the new regulator lasted about 2 weeks and then broke again... thanks mr mechanic....grin
sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching sounds like you window winder spring attached to your winder might be broken or the cogs on the winder have heaps of wear eg not touching
To fix a window in a Daewoo Cielo that has been disconnected from the winder, first, remove the door panel to access the window mechanism. Reconnect the window regulator to the winder by aligning the teeth or clips properly. Ensure all connections are secure, and then test the window operation before reassembling the door panel. If the mechanism is damaged, consider replacing it for smooth operation.
To fix the driver's side window on a 1998 Hyundai Excel, first check the fuse related to the power windows and replace it if necessary. If the fuse is intact, inspect the window motor and regulator for any signs of damage or failure. You may need to remove the door panel to access these components; ensure all connections are secure and replace any faulty parts. If the window still doesn't operate, consider consulting a professional mechanic for further diagnosis.
Identify the fault/problem. Repair or replace
you need to bleed your clutch fluid
you need a wiring diagram, trace power and ground and check where problem might be
90,000km. If you do not replace the belt and the old one snaps, your valves can hit the pistons. Expensive fix.
To fix the no reversing lights on a 1997 Hyundai Excel Sprint, first check the bulbs to ensure they are functioning properly. If the bulbs are good, inspect the reverse light switch, typically located on the transmission, for any issues or disconnections. Additionally, examine the wiring and fuses related to the reverse lights for any damage or blown fuses. If these steps don't resolve the issue, consider consulting a mechanic for further diagnosis.
Depends on the make, but most are as follows :- Remove window winder and door handle, these probably are held on by circlips. Remove arm/elbow rest. Starting at bottom corner you should be Abe to ease out the press/in clips holding the panel in place. Replace in reverse.
Very likely that it's just a horn fuse, check the fuse relay box under the hood located to the front and right.
will + verb = I will fix the window later.be verb + going to + verb = I am going to fix that window tomorrow.be verb + present participle = I am fixing the window later.
go to your Hyundai dealer and make it check