Depends on the make, but most are as follows :- Remove window winder and door handle, these probably are held on by circlips. Remove arm/elbow rest. Starting at bottom corner you should be Abe to ease out the press/in clips holding the panel in place. Replace in reverse.
the linkages to either the handles or the lock or both has come off. here's the kicker... you need to open the door to take of the inside door pannel to fix it. try to remove the pannel with the door closed. or a "skilled" vheicle locksmith could open it from the outside...but it's not cheap.
replace window regulator assembly.
there are several Phillips screws (3 under the window switch pannel, one by the door handle and then one behind each lamp lense in the pannel. )after you remove these the pannel should be pulled off being careful to pll right on the clips. they will make a snap sound, but they shouldn't break. if they do , the local parts store will have replacements (tell them you need "Christmas tree fasteners" they should know what you are asking for) there is a pressure clip that goes in the hole in the upper left corner of the window. this clip normally breaks causing the window to come off track. get a new clip from Cadillac and install it in the hole in the window. lower the track down about half way with the switch and slide the wheel on the bottom of the window into the track and then snap the pressure clip and window into the rear side of the window channel. test the window before installing the door pannel to insure proper travel. if all is good, then reinstall the door pannel and you should be back in business. hope this helps -Jake
The plastic clips on you window regulator have broken. You need to replace the whole thing if those clips have broken. Take the door pannel off and see if there are plastic peices in the bottom of the door.
Remove the inside door panel. You will be able to see the entire window mechanism. Remove the obstruction that is keeping the window from closing.
Replace window seals or if they are repairable you can fix them with silcone, it comes in black to match.
Remove the inside door panel and see what has happened. Only then will you know the problem.
In almost all makes of car you have to replace the window regulator. That's the entire mechanism that holds the window and raises and lowers it.
Remove the 2002 Ford Explorer drivers side inside door panel. The entire window mechanism will be visible. Locate and repair the cause for the window malfunction.
www.hmaservice.com and create login. use postcode 90210 beverley hills ca
You can try replacing the master control switch on the driver's door. If that doesn't fix it you will need a new window motor.
To fix the sliding door window on a Ford Windstar, start by removing the door panel to access the window mechanism. Inspect the window regulator and tracks for damage or debris, and lubricate any moving parts with silicone spray. If the regulator is broken, replace it with a new one. Finally, reassemble the door panel and test the window to ensure it operates smoothly.